The Stay Stuck Kit

1. 1. Prime

   Cleanse the application area with 70% isopropyl alcohol and allow it to dry. If using the optional primer, apply On Guard Skin Shield following its label directions.

2. 2. Apply thin layers

   Apply 3–6 thin, even layers of lace glue, or 4–6 for oily skin. Let each layer dry completely clear before adding the next. Use a cool blow-dryer if needed.

3. 3. Lay, melt & set

   Press the lace into position, finish with Stay Laid Melt & Seal Spray following its label directions, then tie down for 25–45 minutes.

4. 4. Remove gently

   Use Loosen Up Lace Glue Remover following its label directions to loosen the bond. Do not pull the lace away while the adhesive is still holding.

One thick layer instead of 2–3 thin tacky ones. Thin always out-holds thick.

Laying the lace while the glue is still shiny. Wait for matte and tacky.

Removing the wig dry. Always use Loosen Up so your edges stay intact.

1. 1. Apply

   After placing your lace, apply Stay Laid following the bottle's directions. Avoid oversaturating the lace.

2. 2. Set

   Use your melt band to set the finish. For a glue install, follow the full glue-system guidance, including the 25–45 minute tie-down.

Spraying one heavy soak instead of light, layered passes.

Skipping the melt band — the wrap is what gives you that skin-flat finish.

Not waiting the full 10–15 minutes under the band.

Pressing with your palms — use fingertips for a clean blend.